|HP2-Z12 killexams.com | HP2-Z12 dumps | HP2-Z12 exam dumps | HP2-Z12 braindumps | HP2-Z12 exam braindumps | HP2-Z12 real questions | HP2-Z12 practice test | HP2-Z12 practice questions | HP2-Z12 questions and answers | HP2-Z12 dumps free | HP2-Z12 dumps free pdf | HP2-Z12 killexams|
Which networking products are included in the HP E Series? (Select two.)
a wireless access point that operates as a managed AP (controlled mode) only
a wireless access point that operates as a standalone AP (autonomous mode) only
a wireless router
A customer has an HP A7760 AP that operates in standalone (fat) mode. She has purchased several more APs and an access controller. She wants you to convert the current standalone AP to controlled (fit) mode. You have already added the standalone AP to the controller's configuration. Place the steps for converting an HP A7760 AP from fat to fit in the correct order.
What information do all HP E Series APs provide through their LEDs? (Select two.)
whether the AP is performing intrusion prevention
whether data is being sent or received through the Ethernet port
whether the AP is receiving power
whether the AP has detected a rogue AP
whether a software upgrade is in process
The Power LED shows if the AP is receiving power. If the Power LED is blinking, the AP is starting up. If it continues to blink after several minutes, the software failed to load. Try Resetting or power cycling the AP. The Ethernet LED shows if data is being sent or received through the Ethernet port. The LED is off if there is no activity, or blinking if activity is present.
You are resetting an HP E Series AP to factory defaults using its reset button. How many times should the LEDs blink before you release the button?
To reset the device to factory defaults, press and hold the reset button until all LEDs blink three times, and then release the button.
Which device requires switch CLI access for initial configuration?
E-MSM317 Access Device
E-MSM415 RF Security Sensor
E-MSM422 Access Point
E-MSM765zl Mobility Controller
Unlike the E-MSM710 and E-MSM760, the HP E-MSM765 zl has no factory-default LAN port IP address. You will need to assign its LAN port an IP address before you can access the controller through the Web browser interface.
A customer wants you to install a 9-Port 10/100 PoE DSIC in an HP A-MSR 50 Series router. Which requirement must the router meet?
It must have a DC rather than AC power supply.
It must have two open SIC slots that are side by side
It must have a High-Performance Processor Module.
It must have a Voice Co-Processor Module (VCPM).
How do you install an Enhanced Service Module (ESM) on an HP A-MSR30 Series router?
Remove the router's Multi-Service CardA (MSCA) and install the ESM on that card.
Install the ESM in two side-by-side Smart Interface Card (SIC) slots.
Install the ESM in two Multi-Function Interface Module (MIM) slots that are one on top of the other.
Open the router chassis and install the ESM on the main board
To install VPM, VCPMs, and ESMs on an A-MSR 30 Series router, you must open the router's chassis. Follow these steps:
Power off the router and remove the power cord.
Remove all cables from the back panel except the grounding cable.
Make sure that the router is on a level surface and face the router's rear panel towards you. Loose the captive screws on the back panel.
Raise the chassis cover until the front edge is lifted completely from the chassis bottom.
Pull the chassis cover towards you until the tab on the back edge has disengaged from the front panel. Put the cover away.
Match the name of the HP A-MSR router user interface with the type of access that it controls.