|Exam Name||:||Implementing Cisco Video Network Devices (CIVND)|
|Questions and Answers||:||323 Q & A|
|Updated On||:||Click to Check Update|
|PDF Download Mirror||:||210-065 Brain Dump|
|Get Full Version||:||Pass4sure 210-065 Full Version|
|210-065 killexams.com | 210-065 dumps | 210-065 exam dumps | 210-065 braindumps | 210-065 exam braindumps | 210-065 real questions | 210-065 practice test | 210-065 practice questions | 210-065 questions and answers | 210-065 dumps free | 210-065 dumps free pdf | 210-065 killexams|
Which function does BFCP provide?
BFCP is a secondary video channel that is used for content such as slide presentations and desktop sharing.
BFCP is used to determine who is allowed to send media to the content channel.
BFCP provides the ability to pan, tilt, and zoom the far end's camera.
BFCP negotiates who can send DTMF tones and when the tones are sent.
Which MCU supports the use of a lobby screen?
An end user reports that the video they are receiving from a CTS-500 is showing a heavy blue tint. The room sending the video uses indoor artificial lighting. Which procedure must be performed to resolve the issue?
camera focus balance calibration
camera brightness mode: indoor
camera auto adjustment
camera auto adjust room environment
camera temperature map adjustment
Threat monitoring in physical access security can be based upon which three of these? (Choose three.)
Refer to the exhibit.
Acoustic measurements for ambient noise were taken on a candidate for an Immersive Cisco TelePresence room. The numbers on the floor plan represent the dBA readings for each of the six areas of the room. Considering Cisco best practices, what can you conclude about the current acoustic situation in the room?
Only one area is within the noise levels that are recommended by Cisco.
Only one area is not within the noise levels that are recommended by Cisco.
All areas are within the noise levels that are recommended by Cisco.
Two areas are within the noise levels that are recommended by Cisco.
A network administrator is asked to configure a video conference using the Cisco TelePresence MCU 5300. There is a requirement for participants to start with the same layout when joining the conference. How can this goal be accomplished?
Layouts cannot be customized on the MCU 5300.
Configure a custom layout for each user individually.
Configure a custom layout and apply the layout to all new participants.
Allow each endpoint to configure its own layout.
A Cisco TelePresence System 1300 Series endpoint is in the process of booting and the engineer notices a red "X" on the screen for Step 6 in the boot process. What does this red "X" indicate?
The endpoint failed to load its firmware.
There is an error with compact flash.
The endpoint could not obtain an IP address via DHCP.
The touch panel is malfunctioning.
An engineer must pull logs from an Cisco EX90 Codec for a Call setup issue. The engineer opens a Telnet session to the codec and enters the log ctx SipPacket debug 9 command. The engineer places a test call, but sees no debugs on the console. Which action must the engineer take to review the logs?
SSH into the codec to view the logs
Enter the log ctx SipPacket debug all command
Enter the log output on command.
Collect logs from the web interface.
Refer to the exhibit.
Which tab can be used in order to check the call statistics for the Cisco TelePresence Codec C60?
The GUI cannot be used to view call statistics.
An engineer needs to configure cascading to support additional video conference attendees. What are two capabilities when cascading? (Choose two.)
Conductor automatically performs cascading.
A maximum of four multipoint control units are supported.
Cascading is supported for the Cisco TelePresence Server in remotely managed mode.
Cascading is supported for multipoint control units that are registered to Cisco Unified Communications Manager.
All cascaded multipoint control units must be in the same location.